Cts Pot Serial Number

An early 1960s pot from a Gibson guitar. Once decoded, the writing on the back or sides can be very informativeIf you've been reading articles about dating a vintage guitar, you may well have come across mention of pot codes. The pots, or potentiometers to give their full name, are the variable resistors that control volume and tone.

1. Cts Number Search

Better quality pots are often stamped with a number of codes; typically part numbers, date of production, manufacturers codes and resistance values. Many pots don't carry all of this information, but the better quality guitars produced in America regularly do.So where are these codes?

Normally they are stamped or inked onto the back or sides of the pot. So reading them will require opening control cavities, removing scratchplates, or in the case of a semi acoustic, removing the pots entirely. Codes can be worn, obscured by solder and other components, or simply very small. Finding them is not always easy; this is obviously not something for the faint-hearted, but once performed a few times, nowhere near as daunting as it might at first seem. There are many exceptions and variations to the general rules described below, some of which are highlighted in the examples at the end.

Cts Number Search

Part numbersMany pots do not have part numbers, but the larger guitar manufacturers did list pots by part number in their spare parts manuals. You can look up Gibson potentiometers by their part number in the on this site. Manufacturers codesThere are very many electronic companies worldwide producing potentiometers, but most American vintage guitars of the 20th Century used pots by just a few manufacturers. American pot manufacturers had their own numerical codes, for example 134 = Centralab, 137 = CTS and 304 = Stackpole. Although many others were used, these are by far the most important, as they were widely used by the likes of,. Other worldwide manufacturers just used the company name rather than a code. Many also put a country of production.

Production datesProduction dates are usually in three or four digits, one or two digits giving the year (for many US pots one digit refers to the 1950s, two digits to the 1960s), and two giving the week of the year. These often run on from the manufacturer code. For example 1346120 is a centralab pot (134) produced in the 20th week of 1961. But remember this is the date that the potentiometer was produced.

Pots in an older guitar may have been replaced, and this should be considered, especially if the date suggested does not fit with other features of the guitar. What's more, guitar companies sometimes took a very long time to use the potentiometer in question, and they may be considerably older than the guitar itself. Fender, famously bought huge stocks of pots in 1966, and took almost a decade to use them all. Conversely, guitars were also built, but not wired and shipped immediately, resulting in newer pots in older guitars.

This is especially the case for guitars that were only ever shipped in tiny numbers. Pot dates are a useful tool in dating a guitar, but should always be used in conjunction with other known factors, such as hardware changes and serial numbers. Resistance values and taperResistance values are normally listed.

250k, 500k and 1 Meg (1000k) being the most common. The taper of a pot describe how the resistance changes with the turning of the pot. The words LIN on a pot means a linear taper; turned half way, the resistance is at approx. 50% of maximum, three quarters of the way at 75% of maximum etc. AT stands for audio taper. These change logarithmically.